User manual for the Autoblow AI+ inhaler
Connect the power cable to the device and to the mains.
Apply a generous amount of water-based lubricant to the penis and the mouth opening of the device. Add lubricant during use to keep the feeling pleasant.
Push the penis into the insert. If you want to adjust the feel of the insert tighter, pull the insert out of the device and adjust the size of the ring inside the device by pushing a Phillips screwdriver through the hole in the device. Turn the screw counterclockwise until the ring is the size you want. The ring is enlarged by turning the screw clockwise.
Reinsert the insert into the device. This is the best way to do it: Turn on the device using the on/off control, so that the slide inside rises to the upper position. Thread the insert into place using the spatula that comes with the package, pushing so that the lower sealing ring of the insert is below the slide and the upper sealing ring is above the slide. Finally, place the upper edge of the insert in place.
Start and switch programs with the >I button. The blue LEDs of the 10-segment display show the program, i.e. in program 3, the light bar lights up in the third column.
When you adjust the speed with the + and - buttons, the green lights on the light bar show the speed level. After a while the lights will change back to blue to show which program is running.
Whenever you feel you need a short break, press the pause button marked II briefly. During the pause, all the blue lights on the bar are on. When you want to continue, press the pause button briefly and the program will continue from the same point.
The device can be turned off completely at any stage by turning the power off from the ON/OFF switch or by disconnecting the cable from the device.
After use, turn off the device. Carefully pull the insert out of the device and wash the tunnel with mild soapy water and, if necessary, disinfect with a cleaning agent intended for erotic equipment. Shake off most of the water and dry the tunnel by rolling a clean cloth inside it. The outside of the device can be wiped with a damp cloth.
Operation via web application
Connect the power cable to the device and to the mains.
Switch on the device by turning the ON/OFF switch to the ON position.
Press the Pause button for approx. 5 seconds and release when the device lights up green.
Connect the device to the AB_NETWORK network shown in the Wi-Fi networks of your smart device. Enter the password: 123456789. Then connect to an available wireless network.
Copy the "Device Token" password and press "Exit setup". Save the password.
Press the Play button on the device for approx. 3 seconds until the lights flash.
When the device's lights have turned blue, use the smart device's browser to go to app.autoblow.com and paste the "Device Token" password in the field reserved for it and press "Connect".
Now you can control the device with your smart device and you can find amazing additional features for the device in the web application.
When you want another person to use the device with their own smart device, press "Share Your Token" in the application. Copy the link by pressing "Copy Link" and send it by message to the person you want. Another user can directly access the application with their own smart device by clicking on the link you sent.
Note!
The device must never be used without a silicone insert.
The insert must be completely dry when it is inserted into the device.
If the display lights start flashing red, it means that the motor has temporarily overheated. In this case, turn off the device and wait 10 minutes before using it again.
Do not turn the insert inside out (while washing) to prevent it from tearing.
The inner material is best kept silky soft when you sprinkle care powder on the surface and tunnel of the dry insert and store the insert in a plastic bag. Remember to wash off the powder before the next use.
The outer shell of the product must be kept protected from water and moisture.
Store the product away from heat and direct sunlight.
Do not cover the air intake opening at the bottom.